RC Helicopter Blade Balancing

Helicopter Blade balance is governed by some as an art in itself and some people never really. Sure, there RC tools for balancing the rotor helicopter that you buy, but because the money if you do not need? Or, if you need to balance your rotor blades and do not have that tool in the area? E 'can be your rotor blades without a budget balancing tool?

Yes, it is!

Rc Helicopter

This article is the layout of a free and very effective way for you to dynamicallyand static balance your rotor blades. All you need is a bit 'of time and energy to do it well.

Some people have asked why even begin to compensate for the rotor blades and the answer is simple: unwanted vibrations in the RC helicopter to get rid of. It 's a bit like driving a car with one wheel out of balance - it just throws off the whole trip. With helicopters, instead of throwing the flight, can seriously affect its flight performance andcan rip apart even the vibrations caused RC!

The central idea of ​​rotor balancing is to get rid of unwanted vibrations as possible. It may not be able to get rid of, so do not get angry when you will be a little 'vibration remains.

The method that we use are effective and does not take long at all, but it is important that you do it with care and precision. If everything is done, you have to static and dynamicbalanced.

This is what you need - your main rotor blades, a round shaft (market, main shaft ect.) Of any kind, a sharp pencil, electric band or balance, a string, and a nut.

How to balance the blades dynamically

1. The first is that fire is the same for each sheet. Here's how I do it:

2. Place your tree on a round surface.

3. Place a rotor blade to the upper edge of the well rounded, with the balance of yourFinger to push the blade back and forth until it (also known as the center of gravity) the compensation on the ground.

4. Now, mark this point with a pencil and move the blade as you select it.

5. Do this with the second blade also.

6. Now, adjust the blade from the jurisdiction.

7. Move the blade more than enough to see where the balance point for them, and compare the two points.

8. If there are more than 1mm apart, you need to change the balancethe blade has been the closest to the tip, transferring the balance closer to the bolt hole. You can reduce this by adding adhesive tape near the bolt hole at the points of focus does not match on both blades

9. Repeat this process until you have enough tape applied to the correction needed due to gravity (balance point) of the game with two blades, and you're done!

How to balance the blades statically

This type of balanceis the weight of each blade and the other is how we do it here:

1. Take a screw and nut and attach the sheets together and separate them as they are balanced on the run.

2. Mount the rotor blades of the thread. You can do this with a wing or just the wire between the top blade and the mother before putting them together. To ensure that the wire is covered by half of the leaves or just wasted your time. You can also use the centerEnd of fat between two objects of equal height (as a 2 of 4) balance.

3. Pick the leaves from the thread and let it naturally. Check it out at eye level to see if they are level or when a rotor blade is lower than the others. If they are level, then job well done! If you are not on a level, then we have by adding small strips secure the blade, which is higher (it is easier).

The key is to add the strips near the balance point or centerThe severity, so as not to undo all the work you have done. Just add the tape to their level and if they are level, we know that they are balanced! You are now an official RC Blade Balancing-guru! Well done!

RC Helicopter Blade Balancing

reading sunglasses bifocal grilling accessories madhawk 300 rc helicopter